Strobel 141-30, Руководство по эксплуатации

Страница: 26 / 36

22
BA_141-30-40_A6-7_140416_en
5.1
To facilitate machine maintenance, at the machine body or at the lower cover
respectively there is oil drain pipe 133.0764 going through the table top, thus
enabling to drain the oil without removing the machine head.
Oil drain pipe
The oil drain pipe 133.0764 is sealed by means of seal ring 193.0530 and
screw 173.0772 (Fig. 13).
For machine assembly and for shipment the screw borings in cover 112.0085
are sealed by means of ring 193.0530 and screw 193.0772 as well as three
rings 190.0010 and screws 172.0521 each (Fig. 12).
Before mounting head to the table top screws 193.0772 and 172.0521 with the
seal rings have to be removed and the oil drain pipe with sealing washer
190.0178 has to be mounted and sealed (Fig. 13).
To drain the waste oil put a receptacle under the pipe and remove screw
193.0772 only. After having drained the oil screw on screw 193.0772 and seal
it.
Dispose of old oil properly!
A T T E N T I O N ! Danger!
Observe safety instructions under 1.3 and operating
instructions before starting any maintenance or repair
works. Failure to do so can result in serious bodily injuries.
After having drained the oil rinse the machine thoroughly with petroleum and
then refill with new oil.
When removing the inner cover, also oil pipe 196.0716 for the automatic
lubrication which comes from the oil pump through the inner cover with oil, is
removed (Fig. 6)
When re-mounting the inner cover please observe that the lower end of the
main oil pipe is put into the conical opening of the oil outlet piece of the oil
pump (Fig. 6). If you fail to do so the automatic lubrication does not work and
the machine may be damaged seriously by jamming of the shafts in the
bearings.
Before operating the machine make sure that all protection devices (e. g. cover,
belt-guard, etc.) are effective and that all screws are tightened.
Therefore these instructions should be observed carefully and after refilling new
oil make sure the automatic lubrication works properly by briefly operating the
machine and controlling the class at the outer cover.