Strix Systems MWS 100, Руководство по настройке

Страница: 7 / 13

MWS100 Configuration Guide
Strix Systems Access/One Edge
MWS100 Mobile Wireless System
3
4 Installation
Note: The MWS100 is designed for professional installation. Failure to comply
fully with these instructions may void the MWS100 warranty and/or violate local
safety or radio regulations.
1.
Select a mounting location for the MWS100. The MWS100 is designed for
indoor, outdoor and in-vehicle applications. Mount the MWS100 using the
chassis mounting holes and hardware suitable for the particular installation.
Note: In the U.S. the 5150-5250MHz band is only available for indoor applications. It is the
responsibility of the installer to configure the MWS100 to use this band only when it is
installed indoor.
2. Select antennas with gain specifications according to the table below.
Note: The maximum allowable power for each antenna type is noted in the last column. The
installer must set the power correctly for the chosen antennas.
Frequency Antenna Type Connection Method
Maximum
Gain
Maximum
Power Setting
2412-2462MHz
5150-5250MHz
5745-5850MHz
Linear Polarized
Dome
LMR200 Cable (> 3 ft.
length)
4 dBi Full
2412-2462MHz
5150-5250MHz
5745-5850MHz
Omni-directional
Direct connection to
MWS100
3 dBi
5 dBi
5 dBi
Full
2412-2462MHz Omni-directional
LMR200 Cable (> 3 ft.
length)
8 dBi Full
5745-5850MHz Omni-directional
LMR200 Cable (> 3 ft.
length)
12 dBi -3dB (23dBm)
4940-4990MHz Omni-directional
LMR200 Cable (> 3 ft.
length)
11 dBi Full
3. Mount the selected antennas securely following all antenna manufacturer
instructions and recommendations. Provide a suitable length of LMR-200
type antenna cable between each antenna and the MWS100. If using only
one antenna, connect it to the port labeled “MAIN”. Connect a second
antenna to the port labeled “AUX”.