CHECKING/ADDING GASOLINE & OIL
!
!
!
!
1.
DO NOT
use this product for any purpose other than cutting ice fishing holes. Ice augers are precision cutting tools built
for the ice fisherman, and must be properly maintained and handled with caution during both cutting and transporting.
When not in use, always store with blade guard attached.
2.
DO NOT
use attachments other than those available from the manufacturer.
3.
DO NOT
alter this product in any manner; doing so is dangerous and voids all warranties.
4.
DO NOT
allow children or adults weighing under 100 lbs. to operate this equipment.
5.
DO NOT
operate under the influence of drugs or alcohol.
6.
DO NOT
allow your body, loose clothing, drawstrings, scarves, hats or other materials to come in contact with the Powerhead,
Starter Assembly or Auger (Drill) unit at any time.
7.
DO NOT
operate if, upon pulling the starter rope or after drilling holes, the auger (drill) unit rotates or if the rope pulls hard.
Have the unit checked by a qualified mechanic.
8.
DO NOT
allow the engine to run or operate while moving or transporting to another location.
9.
DO NOT
continue to use this product in the event of mechanical or electrical failure.
10. This product produces considerable cutting force that is felt by the operator. Make sure your feet are firmly planted and that
the handles are held firmly while operating this product.
11. Always check the operation of the throttle system to ensure the carburetor control is completely returning to the
idle position when the throttle lever is released.
12.
CHECK
cutting blade screws and collar bolt before and after each use to make sure they are tight.
13. During operation, the auger unit could possibly stop. Be prepared at all times to release the throttle lever.
14. The cutting blades on the ice auger are razor sharp. Use extreme care when handling.
15. After use, the auger blades should be wiped dry and oiled to extend blade life.
It is recommended that everyone who uses this product should read this
StrikeMaster Owner’s Manual before operating.
IMPORTANT SAFEGUARDS
3
Fuel Tank
Cap
Oil
Gauge
The Honda (GX35 engine) is a non-application specific manual. Any further technical engine guidelines that are not covered in the StrikeMaster
Owner’s Manual, refer to the Honda Owner’s Manual.
Unit shipment also includes correct amount of
StrikeMaster API rated SM (as a minimum)
OW-20 4-cycle synthetic engine oil for initial fill (3.4 oz.)
. Honda GX35 engine crankcase capacity has a maximum oil capacity of 3.4 oz.
DO NOT OVERFILL.
Also, running the engine with a low oil level can cause engine damage. This type of damage is not covered by the Distributor’s Limited Warranty.
See Honda Owner’s Manual for other information such as air cleaner, spark plug, and fuel filter.
Your new 4-stroke auger engine does
NOT
come filled with oil or gasoline.
You will need to add StrikeMaster API rated SM (as a minimum)
OW-20 4-Cycle Synthetic Engine Oil to the crankcase reservoir and
unleaded gasoline to the fuel tank prior to your first use. Using a gas/oil
mixture will damage the motor.
Honda Motor Co. requires you use only API rated SM (as a minimum)
OW-20 4-Cycle Synthetic Engine Oil with the Honda 35cc Lite auger engine.
See included Honda Owner’s Manual for step by step instructions or go to:
http://engines.honda.com/pdf/manuals/00X37Z6J6100.pdf
to download
a digital copy.
Suggested position to check oil
Add or check oil at bottom edge of hole, (
Fig 1 right
), while in position
as shown here or on page 9 of the Honda Owner’s Manual.
Use a 5-1/2" tall block for 8" auger
Use a 4-3/4" tall block for 10" auger
Fig 1
