Chapter 1: Hardware
Stride MQTT Gateway User Manual, 1st Edition
1-6
Installation
Mounting
The Stride MQTT Gateway may be used indoors only.
It is designed to be mounted in a vertical position on DIN rail and cooled using natural convection. For
proper cooling, you must provide clearance of at least 5mm [0.2 inches] between MQTT Gateway modules
and at least 10mm [0.4 inches] between MQTT Gateway modules and power supplies or other devices.
Make sure that sufficient air flow is provided for the gateway. Avoid placing raceways or other objects where
airflow could be obstructed. Avoid mounting the gateway above equipment that generates heat; ideally locate
the gateway in the lower part of the panel.
Install the gateway in a place without vibrations.
To mount the gateway:
1. Hook the top of the mounting bracket onto the DIN rail.
2. Press the bottom of the gateway inward until it clicks onto the DIN rail.
To remove the gateway:
A. Pull downward on the mounting clip release.
B. Swing the bottom of the gateway outward.
C. Lift the gateway off the DIN rail.
1
2
B
C
A
NOTE:
Installation of the SGW-MQ1611-WF model in a metal cabinet is not recommended, as the cabinet may
block the Wi-Fi signal.
