R&E Stricker Reha-Entwicklungen GmbH
5
Additional operating instructions Neodrives
Operation
Fig. 1: Key with marking
6.2 Start driving
INFORMATION
Basically, there are two different operating
modes for the rechargeable battery. The battery
is either in „
Active Mode
“ or in „
Deep Sleep
Mode
“. In „
Active Mode
“, the battery consumes
at least 5 mA per hour (self-consumption of the
electronics). To keep the self-consumption as low
as possible, the battery automatically switches to
the so-called „
Deep Sleep Mode
“ after 48 hours.
If you have used the battery in the last 48 hours,
you can start up the handbike via the neodrives
sMMI Connect.
If you have not used the battery in the last 48
hours, switch it on using the On/Off button [4]).
To do this, briefly press the button. Successful
switching on is signaled by the LEDs [5] flashing
three times. The battery is now ready for operation
and you can now start up the handbike via the
neodrives sMMI Connect. (
Fig. 2: Switching on the battery
NOTE
To operate the neodrives sMMI Connect terminal,
please read the supplied neodrives sMMI Connect
Quick Start Guide. This is only available in German
and English.
Fig. 3: neodrives sMMi Connect Kurzanleitung
If you have not yet connected the motor cable to
the battery, the battery will still be set to „
Active
Mode
“ when switched on. If the battery cannot be
switched on, the cell voltage may be too low. In this
case, connect the charger and then press the On/
Off button [4]. The battery is then charged for one
minute.