5. Operation
-----------------------------------------------------------------------------------------------------------------------------------------
■
STARTING ENGINE
WARNING
The cutting head will start rotating upon the
engine starts.
■
Cold start
1.
Release the throttle lever and make sure it
is fully back.
2.
Set the ignition switch to the “-” position.
3.
Push the primer pump several times until
fuel flows out in the clear tube.
4. When the engine is cool, move the choke lever
to the closed position.
5. Place the unit on a flat, firm place. Keep the
cutting head clear of everything around it.
6. While holding the unit firmly, pull out the
starter rope quickly until engine fires.
■
Warm start
■
STOPPING ENGINE
1. Release the throttle lever and run the engine
for half a minute.
2. Shift the ignition switch to the “STOP”
position.
NOTE
If the engine doesn’t stop after stopping the
switch, close the choke so that engine will stop
after a little.
■
Handle adjustment
The handle can be adjusted ± 90° to left and right
side according to the required cut.
1.
Press the unlock button (14) down and hold it
in its lower position
2.
Turn the handle in desired direction to the end.
Make sure the handle engages in position.
•
Do not press the throttle during this operation!
