Strend Pro EO-008.T, Инструкция по эксплуатации, Страница: 23 / 25

EN
TECHNICAL PARAMETERS:
HEATING POWER THERMOSTAT VOLTAGE / FREQUENCY LENGTH OF POWER CABLE
750 W / 1250 W / 2000 W yes 230 V / 50 Hz 1,4 m
SYMBOLS:
Do not dispose of household waste. Instead, environmentally acceptable way, contact the
recycling centers. Please take care the environment.
Protection class I.
Protection class IP20.
Read the entire instruction manual before using fan heater.
Fan heater must not be plugged into a power socket while being serviced.
Caution: Risk of electric shock!
Do not attempt to disassemble of modify the unit or its accessories. In case any part is
damaged, immediately power off the unit and seek the assistance of a specialist.
In accordance with essential safety standards of applicable European directives.
Warning: In order to avoid overheating, do not cover the heater.
Handle device with care.
This side up.
Protect this device from moisture.
IMPORTANT Read these instructions fully before using the heater. Retain these instructions for future reference.
ASSEMBLY OF THE HEATER
Before using the heater, the feet (supplied separately in the carton),
must be fitted to the unit. These are to be attached to the base of
the heater using the 4 self-tapping screws provided, taking care to
ensure that they are located correctly in the bottom ends of the
heater side moldings
SAFETY INSTRUCTIONS (to be read before operating the heater)
- Do not use the heater unless the feet are correctly attached if the heater is used as portable appliance.
- Ensure the power supply to the socket into which the heater is plugged is in accordance with the rating label on the
heater and that the socket is earthed.
- Keep the mains lead away from the hot body of the heater.