EN
ANGLE ADJUSTMENT:
- The air out-let angle can be adjustment during operation.
- The biggest adjustment angle is 20 ° for model BGP1505-02-17 and
30° for
model BGP1505-03-17.
- Firstly, tighten the adjustment knob at both ends of steel-pipe rack, then
gently press the rear of the heater gently with your hand and adjust the out-
let angle.
- To adjust the heater to the horizontal position, gently press the top of the
heater from above with your hand.
CLEANING AND MAINTENANCE
- Before cleaning the appliance, disconnect it from the socket and let it cool down.
- The enclosure is easily to get dirty, wipe it often with soft sponge. For very dirty parts, wipe with a sponge
dipped in < 50
℃
water and mild detergent, then dry the heater enclosure with clean cloth.
- Be careful not to let the water enter the appliance inner. Don’t splash water onto the heater, never use solvent
like gasoline, isoamyl acetate, toluene etc. to clean the heater, in order to protect the enclosure.
- Clean the coupler, dry and pack it in a plastic bag.
- When you store the heater, let it cool down first, keep it dry. Then cover it with a plastic bag, put in the packing
box and store it in a dry, ventilated place.
TROUBLE SHOOTING
- You can solve many common problems easily, saving you the cost of a possible service call. Try the suggestions
below to see if you can solve the problem before calling the authorized service center.
PROBLEM
POSSIBLE CAUSES
SOLUTION
The appliance didn’t heat up, it is
connected to the power supply, the
heat output and the desired
temperature are set
The plug is loose,
bad connection.
Pull out the plug, check the connection of the
plug and socket. Then connect again.
No power in socket
outlet.
Insert the plug in a proper socket.
The appliance didn’t heat up,
t
he
heating element glowing
The input voltage
is too high or too
low
Use power supply according to the rating on the
label
The air inlet grill is
blocked
Clean the air inlet grill.
Keep the heater far away from articles like
curtain, plastic bag, paper and other things
which can cover the inlet or can be easily cover
on the air inlet grill
The appliance didn’t heat up, or
only ventilator worked
The switch knob
was not put at
heating setting
Turn the switch knob to heat setting
Damaged
thermostat knob
Turn the thermostat knob and listen if there is
open/close voice. If there is click the thermostat
