Strend Pro 2212414, Инструкция по эксплуатации

Страница: 47 / 54

STEP 4.
- Attach 3 pcs of 90 mm pins to the flame cover.
- Mount the gas hose on the inlet connector of the
gas burner. Tighten the connection firmly with a
wrench.
- Pull the gas hose over the column.
- Fasten the assembled part to the post with 4 pcs
of M6 x 10 mm screws.
STEP 5.
- Place a Ø 8 mm washer on each of the pins.
- Mount the reflector with 3 washers and 3 M8 mm
nuts.
STEP 6.
- Lift the gas cylinder cover and place it on the gas
cylinder cover beams.
- Attach the gas bottle.
GAS BOTTLE CONNECTION
- Only a certified regulator (37 mbar) as well as a 60 cm long gas hose may be used with the device (under
no circumstances may a hose longer than 1 m be used).
-Lines must not be twisted while the controller is connected to the gas cylinder.
- Connect the other end of the gas hose to the regulator and secure it with a metal clamp.
- Connect the regulator to the gas cylinder and tighten the connection with an adjustable wrench.
- Slowly open the gas valve and perform a leak test. Place the bottle on the stand.
TIGHTNESS TEST
- The leak test must be carried out in well-ventilated areas or outdoors.
- Check that the gas valve actuator is in the off position. Open the gas valve on the bottle and check for
leaks by applying a solution of 1/2 water and 1/2 soap to all gas system connections.
- For the leak test NEVER USE OPEN FIRE.
- If bubbles form on any joint, a leak occurs. Switch off the gas supply and tighten all connections and
repeat the test.
- If the bubbles still form, do not use the patio heater. Contact an authorized service center for assistance.
- Carry out a leak test every year and always when changing the gas cylinder.