before tightening the screws.
MOTION SENSOR SETTING
- The motion sensor is activated by infrared sources that enter the detection range, e.g. people, animals, etc.
- When the motion sensor is activated, the LED light will light up and shall be lit while the motion sensor
senses movement within the detection range or until the set time delay has elapsed.
Suggested hints:
- Do not mount the LED light too high. Ideally, the LED light is mounted between 1.8 and 2.3 meter in height.
- The detection range is affected by temperature, so it may be larger in winter than in summer.
- Do not mount the LED light near trees and shrubs. Their movement could lead to inadvertent switching on
and off of the LED lamp.
- The motion sensor is more sensitive to side movements than front and back movements.
- The detection range can be set manually using the controller or by covering some parts of the lens.
Sensitivity setting:
- Motion sensor sensitivity can be adjusted to different ambient light levels:
•
Setting the controller to the
☽
position means that the motion sensor will detect a light level
movement of less than 50 lux.
•
Setting the controller to the
☼
position means the motion sensor will detect daytime movement.
Detection distance setting:
- The detection distance can be adjusted by turning the controller.
- If you want to reduce the detection distance, turn the knob counterclockwise.
- If you want to increase the detection distance, turn the knob clockwise.
The minimum detection distance is 0.5m and a maximum of 10m.
Time delay setting:
- The time delay is activated as soon as the motion sensor has detected movement.
- Turn the regulator to set the LED light time.
CLEANING AND MAINTENANCE
- If you need to clean the light, first unplug it from the power source and let it cool down.
- Do not use abrasive cleaners and organic solvents to clean the surface of the light as this will damage it.
- All service works or installation of the light must be carried out only if the light is switched off and
disconnected from the power source.
