6
Fig. 5
Fig. 6
5. Connect the pressure hose to the pressure gun.
The hose should easily click into place. Ensure the
release trigger is not pushed in when connecting
the pressure hose. To remove the hose push in the
release button and pull the hose out.
6. Connect the pressure washer to your hose pipe via
the ½ inch inlet connector (Figure 6).
Once the product is assembled, your pressure
washer is ready to use. You do not need to
disassemble the product after using the
pressure washer. Just store in a dry place at
room temperature.
(If you want to dissasemble the pressure
washer, simply reverse the steps outlined in
Assembly Instructions).
Directions For Use
Before use
Before using the pressure washer, ensure the adjustable line nozzle is firmly in place. Never use the pressure washer
without the line nozzle being firmly in place.
The line nozzle can be adjusted to change the width of the pressurised water output for more coverage. Simply rotate
the nozzle to adjust the width of the jet spray.
Once both the water supply and power supply are on, the pressure washer will start as soon as you pull the trigger on
the pressure gun.
I
MPORTANT: When using the pressure washer, please wear protective eyewear, protective gloves and boots with strong grip.
Using The Pressure Gun
When using the pressure gun, ALWAYS ensure
that you use both hands to provide a firm grip.
Never use only one hand.
Before pulling the trigger, turn the safety lock off
first, (located at the base of the handle) then
point the pressure washer gun to where you
want to clean. Then press the trigger.
IMPORTANT: After 1 minute of continuous use, release the trigger to allow the unit to cool down. Let it cool
down for a few seconds, and repeat.
Fig. 7