BLASTER WATER BROOM INSTRUCTIONS
DO NOT USE ON FINE PAINTED SURFACES SUCH AS CARS, CAMPERS, TRAILERS.
1. Ensure ON/OFF (B) switch and water tap is OFF
2. Attach the Blaster Water Broom Head by unscrewing The Blaster Brush Head (D) (if attached) and reattaching
the Blaster Water Broom Head and retighten (D) by hand securely.
3. Connect the pole to a garden hose with hose connector (A) (if not already connected).
4. If no universal hose connector is required (USA), unscrew universal male connector and connect hose directly
to pole.
5. Loosen middle pole fastener slightly (C), and adjust the telescopic pole to the desired length, then retighten
securely by hand.
6. Ensure water switch on pole and water tap is OFF
7. Connect the pole to a garden hose with the universal hose connector.
8. If no universal hose connector is required (USA), unscrew universal male connector and connect hose directly
to pole.
9. Loosen middle pole fastener slightly, and adjust the telescopic pole to the desired length, then retighten
securely by hand.
10. Avoid leakage by ensuring all parts are securely screwed together before turning on the tap.
11. Turn ON the tap.
12. Switch the water switch to ON (B) and proceed to wet surface.
13. Depending on application, either leave water switch ON (B) while scrubbing and sweeping surface, or wet
surface, switch water switch OFF (B), scrub, switch ON (B) and direct loose dirt to drainage.
14. At times, while water switch is ON (B), lift Blaster Water Broom and use water pressure to thoroughly direct
dirt and debris away, as well as rinsing hard to reach areas.
15. Spray away mud, garden refuse and dirt from surfaces to ensure thorough cleaning.
Ideal for...
Carpets
Garden Paths
Patios & Paving
Factory Floors & Warehousing
Streetwize Accessories:
Unit 1, Royce Trading Estate, Ashburton Road West,
Trafford Park, Manchester M17 1RY
Sales enquiries:
Technical enquiries:
www.streetwizeaccessories.com
SWCWB6-Manual.qxp_Layout 1 19/03/2018 10:09 Page 1
