The rear end of the elevator cable in the working position.
The rear end of the rudder cable in the working position.
This sketch shows the factory recommended location of the launch
blade on the wing tip. On the left wing tip there is a hard point made
of epoxy and microballoons located as shown on the sketch. To
install the blade within this hard point, it must be located about
12.5mm from the tip and about 8.5mm forward of the hinge line.
Depending on how your fingers are gripping the blade, this may or
may not be a convenient location for you. If you do not want to use
the recommended location for the blade, and have to install it outside
of the hard point, you may want to use extra reinforcement patches
as shown on the next picture.
To install the launch blade, make an elongated hole at the desired
location. Check the shape of the hole with the actual launch blade to
assure a reasonably tight fit. If you are a very strong launcher and/or
you chose to install the blade outside of the factory hard point, a
reinforcement around the blade is recommended. On the picture, a
single layer carbon reinforcement is shown.
