STRATUS Floor Plate 2 post Lift Installation & Operation & Maintenance Instructions
22
3.11 Install the AC contactor and the cover of the motor back on (Fig. 21).
Fig. 21
5.9 Routing the safety release cable
1.The safety lock has been pre-installed.
2. Install safety lock release cable to connect the safety lock on the main column and vice column. (Fig 22)
3.Install safety lock cover.
NOTE: Press the single point lock release lever on the main column to check if this lever can release the
mechanisms in both columns at the same time. Adjust the safety lock release cable adjustment screw if
necessary, until the lever can release the mechanisms in both columns at the same time.
Fig. 22
