Stratus SAE-C12X, Инструкция по установке, эксплуатации и обслуживанию

Страница: 17 / 26

17
Step14: Trial running. (See Fig 18)
Get familiar with lift controls by running the lift through a few cycles before loading vehicle on lift. This step is of par-
ticular importance for it can check if the oil hose is well connected. The connection is qualified when there is no ab-
normal sound or leakage after having been tested for 5
- 6 times.
Bleeding the hydraulic system
Unscrew but don't remove the nut on top of the oil cylinder and slightly press the UP button until oil gets out. Screw
the nut tight thereafter. After bleeding, oil level in power unit reservoir may be down. Raise and lower lift several
cycles. Add more oil if necessary to raise lift to full height. It is only necessary to add oil to raise lift to full height.
Step13: Install lifting arms. (See Fig 17)
Connect the lifting arm and the carriage. The arm pin shafts must be greased at the installation Ensure the arm lock
can engage and release effectively. .
Attention: Install Lifting arms and fix feet protection bars ONLY after the complete assembly has been erected and
anchored.
FIG 17
FIG 18
No. Name Qty.
1 Arm shaft 2
2 Socket head cap screws M10×16 2
3 Arm bottom pad 2
4 Welding of support arm 2
5 Anti - collision tape 1
6 Socket head cap screws M8×30 2