Stratus ftserver 3300, Руководство по планировке объекта

Страница: 25 / 138

Cabinet and Monitor Requirements 2-1
Chapter 2
Cabinet and Monitor Requirements
2-
For requirements related to supplying your own cabinet and monitor for use with
ftServer systems, see:
•
“Rack Requirements” on page 2-1
•
“Monitor Requirements” on page 2-4
Rack Requirements
If you are providing your own cabinet for the ftServer system, make sure the cabinet
contains a 19-in. wide rack that meets the Electronic Industries Association (EIA)
310-D standard.
For ftServer 6600 systems, use a cabinet that is either 24U or 38U high.
For ftServer 3300 and 5600 systems, use a cabinet that is either 25U or 42U high.
Cabinet Requirements for ftServer 3300, 5600, and 6600 Systems
Make sure that:
•
The cabinet contains two front and two rear vertical EIA rails, one in each corner of
the cabinet, that have the EIA universal square-hole pattern as defined in the EIA
310-D specification.
•
The front vertical rails extend at least 0.5 in. (1.27 cm) beyond the inside edge of
the accessory leg, if present, to allow the mounting rails to be fitted. See
Figure 2-1 .
•
The distance between the front vertical rails and the inside of the front door is at
least 3.0 in. (7.62 cm).
•
The distance between the rear of the system chassis and the inside of the rear door
is at least 6.0 in. (15.24 cm).
•
The vertical mounting rails are plated or some other method is used to ensure
continuity for grounding between installed equipment.
•
Cable management brackets are provided to support and constrain data and power
cords so that the cables do not interfere with air flow out of the rear of the
enclosures, and so that the connectors do not disconnect or break.