Stratus ftServer 2510, Руководство по планировке объекта

Страница: 56 / 104

Ethernet Cables
4-6 Stratus ftServer 2510, 4410, and 6210 Systems: Site Planning Guide (R627)
You will need Ethernet cables for the following connections:

From two or four embedded Ethernet ports on the system and Ethernet ports on
U574F-LC or U575F Ethernet adapters to network connection points
N O T E
Two Ethernet ports are typically paired and teamed in
software for fault tolerance. Each member of the pair
requires an Ethernet cable.

From each ftScalable Storage RAID controller tray, if present, to a network
connection point, for Web management of ftScalable Storage systems

From a management PC to a network connection point, for Web management of
ftScalable Storage systems
The same network must provide access to the RAID controllers on the
ftScalable Storage RAID controller tray from the PC.
Table 4-3 describes the cables you must supply for network connectivity. Be sure to
provide cables of sufficient length for the distance between the system and a wall jack
or hub.
Table 4-3. Customer-Supplied Ethernet Cables
Component Quantity
Marketing
ID/Cable Length
Cable Type
VTM Ethernet port
†
2 N/A. You must
supply these
cables.
The maximum
allowable
distance from
these ports to a
switch or a hub is
328 ft (100m).
24 AWG Unshielded Twisted Pair
(UTP) EIA/TIA-Verified, Category-3
or Category-5 wire, with RJ-45
modular connectors terminated with
pair-wiring adhering to the EIA/TIA
568-A or EIA/TIA 568-B standard.
For connections to an Ethernet hub
or switch, provide a
straight-through cable.
For 100- or 1000-Mbps (fast
Ethernet) operation, provide
full-duplex, or Category-5 Ethernet
cables.
System Ethernet port 2 or 4
U575F Two-Port,
Copper, 10/100/1000
Base-T Ethernet PCI
Adapter (gigabit copper
adapter for servers) 1 for each
port, typically
teamed for
fault tolerance