Stratus ftServer 2500, Руководство по планировке объекта

Страница: 63 / 106

Ethernet Cables
Communications Line Planning 5-7
Table 5-3 describes the cables you must supply for network connectivity. Be sure to
provide cables of sufficient length for the distance between the system and a wall jack
or hub.
Table 5-3. Customer-Supplied Ethernet Cables
Component Quantity
Marketing
ID/Cable Length
Cable Type
VTM
Ethernet port
†
2 N/A. You must
supply these
cables.
The maximum
allowable
distance from
these ports to a
switch or a hub is
328 ft (100m).
24 AWG Unshielded Twisted Pair
(UTP) EIA/TIA-Verified,
Category-3 or Category-5 wire,
with RJ-45 modular connectors
terminated with pair-wiring
adhering to the EIA/TIA 568-A or
EIA/TIA 568-B standard.
For connections to an Ethernet
hub or switch, provide a
straight-through cable.
For 100- or 1000-Mbps (fast
Ethernet) operation, provide
full-duplex, or Category-5
Ethernet cables.
System Ethernet port 2 or 4
U575F Two-Port, Copper,
10/100/1000 Base-T
Ethernet PCI Adapter
(gigabit copper adapter for
servers) 1 for each
port, typically
teamed for
fault tolerance
U574F-LC Dual-Port
1000Base-SX Fiber
Ethernet PCI Adapter
(gigabit fiber-optic adapter
for servers) 1 for each
port, typically
teamed for
fault tolerance N/A. You must
supply these
cables.
The maximum
distance
between the
adapter and a
switch is 902 ft
(275m).
Multimode, 62.5- or 50-micron,
DUAL fiber cable with LC-type
connectors to the PCI adapter,
and connectors on the other end
that are compatible with your site
network switch.