Page 6 of 9
Note:
To install into an existing cup holder, use the
Cup Mount (04). Use the Tripod Mount (05) to install
directly onto the dash.
•
Continue for mount installation instructions.
Note:
Be sure to leave clearance to allow airflow
between the firewall and heater intake.
•
Connect Wiring Harness (02) to back of heater.
TEST HEATER FUNCTION
•
Turn on the key switch and test heater
function, ensuring correct harness connection
on driver and passenger side controls.
IF USING THE TRIPOD MOUNT (05)
•
Place the Tripod Mount onto the chosen
mounting location and secure with Self
Tapping Screws (H5) in three places. (Note:
After placing the first screw, rotate the mount
clip to access each screw hole as shown).
•
Attach Heater to Mount Clip.
IF USING THE CUP MOUNT (04)
•
Depress locks on side of Cup Mount & rotate
bottom to disengage teeth.
•
Place Cup Mount assembly in dash cup holder.
Insert screw (H2) with washer (H1) & nut plate
(06) through the cup holder’s drain hole. (Do
not tighten).
•
Push down Cup Mount top piece to set the
cup mount depth. The lip seal will conform to
the varying dash surface to ensure there are
no gaps. Tighten screw (H2).
•
Snap the Heater onto the Mount Clip.
