Fit the Front Wall Channels over the Front Wall Sheets and
into the Corner Brackets. Line up the pilot holes and fasten
two 10x16 self-drilling screws through the Corner Brackets
and into the Front Wall Channels.
Figure 4.10
Figure 4.7
Fasten four 10x16 wafer-head tek screws through the Strut
Bracket and into the top of the Wall Channel. Ensure a
spacing of 830mm from the Strut Bracket end to the front
Corner Bracket. Complete for both sides.
Confirm the Corners are Square before fastening the screws.
Fasten four 10x16 wafer-head tek screws through the top of
the Corner Brackets of the Front Wall. Fasten two 10x16
wafer-head tek screws through the top of the Corner
Brackets of the Rear Wall.
Figure 4.8
Front wall
Channel
10x16 self-drilling
screw
Corner
Bracket
Two screws through these holes
10x16 wafer-head
tek screw
Check Square
830mm
10x16 wafer-head
tek screw
Strut Bracket
Confirm the Corners are Square before fastening the screws.
Fasten a Hinge to the top face of both rear Corner Brackets.
Fasten the Hinge to the Corner Bracket using three 10x16
wafer-head tek screws in both ends.
Figure 4.9
Hinge
10x16 wafer-head
tek screw
Rear Corner Bracket
