Stratasys uPrint, Руководство по обслуживанию, Страница: 76 / 383

uPrint/uPrint SE Service Manual 4-29
Power Distribution I/O Card
Required Tools
•
5
⁄
16
” nut driver or standard screwdriver.
• Phillips screwdriver
Hardware
• 6-32 x
1
⁄
4
” Phillips pan head screws (x3)
Removing the I/O card
1.
Remove the top panel. See Removing the top panel on page 4-5.
2.
Remove the side panels. See Side Panels on page 4-7.
3.
Open the electronics bay. See Opening the electronics bay on page 4-15.
4.
Touch the metal plate of the electronics bay cover to discharge any static electricity.
5.
Disconnect the 6 cables from the I/O card by pushing in on the locking tabs and pulling
outward. See Figure 4-51.
Figure 4-51: I/O card cable locations
6.
Disconnect the thermocouple from the back side of the I/O card by pulling outward. See
Figure 4-52.
Figure 4-52: Chamber thermocouple wire location
Disconnect all 6
of the cables
Disconnect the
chamber
thermocouple