Stratasys uPrint, Руководство по обслуживанию, Страница: 62 / 383

uPrint/uPrint SE Service Manual 4-15
Electronics Bay Components
The main circuit boards and power supplies for the printer are located in the electronics bay.
Lower Electronics Bay Cover
Required Tools
•
5
⁄
16
” nut driver or standard screwdriver.
Hardware
• 10-32 x
3
⁄
8
” slotted screws (x3)
Opening the electronics bay
1.
Remove the top panel. See Removing the top panel on page 4-5.
2.
Remove the side panels. See Side Panels on page 4-7.
3.
Remove the filament tubes from the Y connectors by pushing down on the ring and
pulling back on the filament tubes. See Figure 4-32.
Figure 4-32: Removing the filament tubes from the Y connectors
4.
Using a
5
⁄
16
” nut driver or standard screwdriver, remove the 3 mounting screws on the
top of the electronics bay cover. See Figure 4-33.
Note: When reinstalling components in the Electronics Bay area note that cable
J401 is unused. (Not connected)