Stratasys uPrint, Руководство по обслуживанию, Страница: 167 / 383

4-120
11.
Remove the substrate sensor. See Removing the substrate sensor on page 4-64.
12.
Using a
1
⁄
2
” box wrench, remove the X belt tension adjuster by loosening the inside nut
and then backing the bolt out of the mount. See Figure 4-207.
13.
Remove the tensioning fork and pulley from the X motor belt.
Figure 4-207: X belt tension adjustment bolt location
14.
Using a cutters, remove the X motor cable connector wire tie. See Figure 4-208.
Figure 4-208: X motor wire tie locations
15.
Disconnect the X motor cable by pressing in on the tab and pulling outward. See Figure
4-209.
Figure 4-209: X motor cable connector location
Loosen X belt
adjustment bolt
Cut and remove
wire tie
Disconnect X
motor cable