Objet260 User Guide
6 Operating and Maintaining the Objet260 3D Printer
DOC-37004 Rev. E
6-40
8. When the following screen appears, remove the transparency.
Figure 6-49 Head Alignment wizard—steps 8–10
The transparency sheet is printed with sets of vertical lines in seven
columns, each showing the results from a different print head.
Figure 6-50 Sample head-alignment test
Note:
There is no column for head H7 because its alignment is used as a
reference for aligning all other heads.
9. For each column of lines, use a magnifying glass or loupe to inspect pairs
of consecutive rows printed on the transparency to see where the vertical
lines align.
Figure 6-51 Comparing rows of alignment lines
Note:
It does not matter which pair of lines you inspect, since they were all
printed by the same head. Choose a pair of clearly printed lines for the
inspection. (Since some nozzles may not print clearly, you may have to
inspect several pairs of lines to properly view the alignment.)
