uSEr MAnuAL
w w w. S t r A n D L i g h t i n g .C o M
AurorA LED Strip 12 CELL
32
DMX512 CONNECTION
• The DMX cable should be terminated at the last unit in a run, using a DMX terminator. Solder a 120
Ω
1/4W resistor between pin 2(DMX-) and pin 3(DMX+) into a 5-pin XLR-plug and plug it in the DMX-
output of the last unit.
• Connect the unit together in a `daisy chain` by XLR plug from the output of the unit to the input of the
next unit. The cable cannot be branched or split to a `Y` cable. DMX 512 is a very high-speed signal.
Inad- equate or damaged cables, soldered joints or corroded connectors can easily distort the signal
and shut down the system.
• The DMX output and input are configured as pass-through connectors in order to maintain the DMX
circuit, should the power to one of the unit’s be disconnected.
• Each lighting unit needs to have an address set to receive the data sent by the controller. The address
number is between 1 - 512 (but not all starting addresses are available depending on DMX Mode).
• 5-pin XLR: Pin 1: GND, Pin 2: Negative signal (-), Pin 3: Positive signal (+), Pin 4/Pin 5: Not used.
Содержание Aurora LED Strip
Страница 1: ...Aurora LED Strip 12 Cell User Manual...