Stow MS-70, Руководство по эксплуатации и запасным частям

Страница: 21 / 94

STOW MS-70 MIXER — OPERATION MANUAL — REV. #3 (03/26/10) — PAGE 21
STOW MS-70 PLASTER/MORTAR MIXER — INSPECTION
Figure 9. Engine Oil Dipstick (Removal)
3. Insert and remove the dipstick without screwing it into the filler
neck. Check the oil level shown on the dipstick.
4. If the oil level is low (Figure 10), fill to the edge of the oil filler
hole with the recommended oil type (Table 7). Maximum oil
capacity is 2.33 qts. (1.09 liters)
NOTE
Reference manufacturer engine
manual for specific servicing
instructions.
Figure 10. Engine Oil Dipstick (Oil Level)
Before Starting
1. Read all safety instructions at the beginning of manual.
2. Clean the mixer , removing dirt and dust, particularly the
engine cooling air inlet, carburetor and air cleaner.
3. Check the air filter for dirt and dust. If air filter is dirty,
replace air filter with a new one as required.
4. Check carburetor for external dirt and dust. Clean with
dry compressed air.
5. Check fastening nuts and bolts for tightness.
ALWAYS wear approved eye and
hearing protection before operating
the mixer.
NEVER place hands or feet inside the
engine guard cover while the engine is
running.
ALWAYS shut the engine down
before performing any kind of maintenance
service on the mixer.
Engine Oil Check
1. To check the engine oil level, place the mixer on secure
level ground with the engine stopped.
2. Remove the filler dipstick from the engine oil filler hole
(Figure 9) and wipe it clean.
CAUTION CAUTION CAUTION CAUTION CAUTION
Eyesight and Hearing
Protection
CAUTION CAUTION
CAUTION CAUTION CAUTION
Inspection &
Maintenance Saftey
e p y T li O . 7 e l b a T
n o s a e S e r u t a r e p m e T e p y T li O
r e m m u S r e h g i H r o C ° 5 2 0 3 - W 0 1 E A S
ll a F / g n i r p S C ° 0 1 ~ C ° 5 2 0 2 / 0 3 - W 0 1 E A S
r e t n i W r e w o L r o C ° 0 0 1 - W 0 1 E A S