With each wash cycle.
Compartment
For programmes with pre-wash only.
(Follow the user instructions!)
Electric indicator on control panel (if provided).
Check the rinse aid level
(On models with water softener system only.)
Electric indicator on control panel (if provided).
If there is no salt warning light in the control panel
(for some models), you can estimate when to fill the salt into
the softener by the number of cycles the dishwasher has run.
Check the regeneration
salt level
Load the baskets
Select a programm e
T urn on the water tap ,close the door . The machine will star t working after about 10 seconds.
Runnin g the dishwasher
Sw itch off the applianc e
Turn off the water tap,
unload the baskets
Fill the dete rgent dispenser
Warning: wait a few minutes ( about 15 m inutes) before unloading the d ishwasher to avoid handling
the dishes and utensils while they are still hot and more susceptible to break.
They will also dry better.Unload the appliance, starting from the lower b asket.
Changing the programme
Add forgotten dishe s in the
dishwasher.
Scrape off any large amount of leftover food. Soften remnants of burnt food in pans,
then load the baskets. Refer to the dishwasher loading instructions.
Press the Programme Button until the selected programme lights up.
( See the section entitled
Operation instruction
)
“
”
When the working cycle has finished, the buzzer of the
dishwasher will soun d 8 times, then stop .
Turn off the appliance using th e On/Off B utton.
If the app liance is switched
off during a wash cycle.
Open the door care fully.
Hot steam ma y esc ape
when the door is op ened!
If the app liance is switched off during a wash cycle, when switched
on again, please re-select the washing cycle and o perate the dishwasher
according to the original Powe r-on state ).
Switch on the ap pliance
Open the door,press the On/Off button to switch on the appliance .
1.Open the door a li ttle to stop the dishwasher.
2.After the spray arms stop working, you can open the door completely.
3.Add the forgotten dishes.
4.Close the door, the dishwasher will star t running again after 10 seconds.
For detailed operating m ethod read the corresponding content on the instruction manual.
1. A running cycle can only be modified if it has be en running for a shor t time. Otherwise the detergent
may have already been releas ed and the water already drain ed. If this is the case, the detergent
dispenser must be refilled.
2. Open th e door.
3. Press the
for mo re than 3 seconds to cancel the running programme.
4. Select a new prog ramme.
5. Restart the dishwasher.
Programme Button
5
Содержание ST INTDW45
Страница 30: ...28...