STOVES SEH600iR, Руководство пользователя и инструкция по установке

Страница: 15 / 28

USING THE HOB - INDUCTION
Hob Status Codes Fault Description Action
"r"
Max Power Setting reached (Only on 13 Amp
versions)
Reduce the power settings on other zones
"U"
Indictes no pan or suitable pan on the cook
zone
Ensure the correct pan size is selected and that the pan is suitable for
induction use
"o"
Indicates control knob has been left in th on
position.
Turn the control knob to the off position to reset
"H" Residual Heater
"H" will switch off when the glass surface drops below 55
o
C
"c" Induction generator over temperature
Check the installation and free air flow to the hob are as per the installation
instructions, Normal operation will resume when the appliance is cooled
"C"
Induction heater over temperature the product
will automaticlaly reset, indicates a overheated
pan.
Allow hob to cool and normal operation will resume
(8888) In all the
displays
Control knobs not turned on when electrical
supply is switched on at the cooker socket
Turns the controls Off before switching the power on to the appliance.
Refer to Troubleshooting chart. Also try
switching power off/on to the appliance
to reset the electronics, if the problems
persist call, the customer service hotline
for further assistance.
Appliance Errors &
Alarms
Fault Description
F / - Knob control fault
Turn the controls to the off postion and turn the power off and back on to
reset the system
F / L Knob control limits fault
Turn the controls to the off postion and turn the power off and back on to
reset the system
F / E
User interface temperature sensor (NTC) error
Allow the hob to cool. Turn the controls to the off postion and turn the
power off and back on to reset the system
F / t User interface temperature sensor (NTC) error
Allow the hob to cool. Turn the controls to the off postion and turn the
power off and back on to reset the system
F / c User interface overtemperature Remove hot pans from the display areas and allow the hob to cool
F / H
EEPROM error
Allow the hob to cool. Turn the controls to the off postion and turn the
power off and back on to reset the system
F / J Knob control fault
Allow the hob to cool. Turn the controls to the off postion and turn the
power off and back on to reset the system
F / 0 User interface microcontroller fault
Allow the hob to cool. Turn the controls to the off postion and turn the
power off and back on to reset the system