STOVES 720EF, Руководство пользователя и инструкция по установке

Страница: 29 / 40

27
Method 2: Housing unit with
internal height less than 710 mm.
Note: You will not need the 2 side
trims (692 mm long) or the appliance
runners for this installation. You will
need the 2 runners to fix to the
adjacent cabinets.
Before you start;
Before removing the bottom shelf or
modifying the housing unit, make sure
that it will remain structurally sound,
eg; by fixing to adjacent cabinets,
floor or worktop.
You may have to cut into or remove
any rear cross members to obtain the
550 mm minimum depth.
To obtain the required 715 mm height,
you may have to lower or remove the
bottom shelf - remove any cross rails
and reposition brackets.
To fix the runners
1. Take the side trims, hold it against
the side of the base unit, and use
it to mark off the 692 mm from the
top edge of the side unit, to the top
edge for the runner.
Note: This ensures a 5 - 8 mm
clearance from the underside of
the worktop to the top of the
appliance.
2. Measure 50 mm from the front
edges of the base units, to mark
the front edge for the runners.
3. Take 6 of the No 8 x 12 mm
(Black) chipboard screws and
screw the runners into position the
right way up as shown.
4. If necessary, adjust the height of
the plinth to just below the bottom
edge of the runners.
INSTALLATION INSTRUCTIONS
23892 02 - Q721EF/720EF 03/04/2001 15:31 Page 29