Page 7 of 7
Password is: 1-2-3-4.
Automatically goes to AUTO from SG-OFF mode.
Default preset time in Auto mode is 1 minute.
Delay model.
SG-OFF LED shows SG-OFF mode.
Repeating setting for buzzer and output connector in Auto and Timer mode.
SENSING LEVEL ADJUSTMENT (Height Adjustment)
The sensing range of the EMU (
Electronic Monitoring Unit
) is over 4 meters (around 12 feet) at a radius of 110 degrees.
Each time the motion sensor is activated, the green INDICATOR LED flashes (
#8 on EMU Diagram
).
STOVE GUARD
features an adjustable sensing height level to prevent the activation of the stove by small
children or pets that might be detected by the motion sensor (PIR).
There is a screw located underneath the EMU, which allows you to adjust the viewing height range of the PIR.
Normally this does not need to be adjusted.
Note
: This adjustment should only be done in the following situations:
1.
It is determined that the PIR is detecting movements other than those of the intended
STOVE GUARD
user (
such
as small children, pets, etc.
) which will pass within the lower portion of it’s detection field.
To
RAISE the detection field
when the EMU cannot be located higher, slowly turn the screw to the
LEFT
.
2.
STOVE GUARD
is not detecting the movements of the user because its location is set very high up; the user is
very short, or seated in a wheelchair.
To
LOWER the detection field
for these situations, slowly turn the screw to the
RIGHT
.
TROUBLESHOOTING
Why is there a very slight “…humming sound…” coming from the Stove Guard’s power box?
This humming sound is normal; the sound is emitted from the energized coils in the power relays. These relay coils must
be energized to allow the operation of the safety feature called “…Fail Safe…”. This important added safety feature makes
the Stove Guard tamper proof, this means that if any wires are purposely disconnected to try to disarm Stove Guard the
kitchen stove will not operate.
If this slight humming sound is annoying to you, try to lay the Power Box on the floor behind the stove instead of
mounting it to the wall… When attached firmly to the wall or metal surface the sound may be amplified.
The EMU’s LED’s do not light up:
Check the stove fuse or circuit breaker to ensure power is reaching the stove.
Check that all the connections to the
STOVE GUARD
Power Box and EMU are properly connected and press
the AUTO button.
Check the fuse in the
STOVE GUARD
Power Box
(#2 on POWER BOX diagram
).
The green INDICATOR LED flashes without any reason:
Avoid placing the EMU within the proximity of the following sources of interference that might accidentally trigger the PIR
(
Motion Detector
):
Reflective Surfaces: direct air flow from vents, fans and windows.
Sources of steam or cooking oil vapor.
Infrared light sources: TV or other IR Remote Controls
Objects causing temperature changes: such as heaters, refrigerators, toasters and ovens.
Do not place objects that a pet can climb onto (
e.g. a cat on furniture
) within 10 feet of the EMU, or furniture
higher than 3 ft.
In addition, do not aim the EMU at a stairway a pet may have access to.
