![Stortech MDVR404 Series Скачать руководство пользователя страница 2](http://html1.mh-extra.com/html/stortech/mdvr404-series/mdvr404-series_quick-start-manual_1382893002.webp)
MDVR404 Series
Whilst every effort has been made to ensure the
accuracy of the information provided, no liability can
be undertaken for any errors or omissions. All
dimensions stated in this document are approximate.
Stortech Electronics Ltd reserves the right to alter the
specifications and introduce changes without prior
notice. © Stortech Electronics 2018
Tel: +44 (0) 1279 419913
www.stortech.co.uk
MDVR404_Quick Guide 21052018
Introduction & Warnings
Before installing please read the following warnings carefully. Stortech CCTV
strongly recommends that all connections and installations are carried out by
qualified personnel.
PLEASE READ THIS BEFORE ATTEMPTING INSTALLATION AND USE
The recorder uses a DC power supply. Input DC range is 8V-36V. Please pay attention
to VDD and GND when connecting the power. DO NOT make the DVR short-circuit.
Initial power must be over 30W (Specific power consumption will vary depending
on the external equipment).
Power supply must be over 30W.
From the vehicle supply to the MDVR all power cables must be able to withstand
5 Amps or more.
Install the equipment in the dry and avoid damp, drips, water spray etc.
To extend the life of the equipment, please install within the part of the vehicle
that has the lowest vibration. We recommend a horizontal installation position.
The equipment should be installed inside the vehicle where there is good
ventilation. Do not install in a closet type environment.
Ensure that equipment is away from any heat source in the vehicle and is not
covered. Also location must be as far as possible away from an electromagnetic
environment, which may cause strong interference.
Ensure that passengers and drivers cannot interfere or damage any components
of the equipment.
The installation and all materials must bear the correct fuse rating.
It is recommended that the power cords are kept away from any heat source and
are sealed to prevent water and oil ingress and short circuiting.
Please do not open or attempt to install the equipment without professional
guidance.
Attention:
The device will automatically format the hard disk/SD card to pre-allocate the
storage space before starting to record video.