STONEX SH5A, Быстрый старт

Страница: 10 / 11

This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the following
measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver
is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Caution: Any changes or modifications to this device not explicitly approved by manufac-
turer could void your authority to operate this equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to the following
two conditions: (1) This device may not cause harmful interference, and (2) this device
must accept any interference received, including interference that may cause undesired
operation.
The device has been evaluated to meet general RF exposure requirement. The device
can be used in portable exposure condition without restriction.
NOTICE:
The SAR limit of FCC and ISED is 1.6 W/kg averaged over one gram of tissue. Device types
SH5A ( FCC ID: Y44-SH5A and IC: 9932A-SH5A ) has also been tested against this SAR limit. The
highest SAR value reported under this standard during product certification for use on the body is
1. 482 W/kg. This device was tested for typical body -worn operations with the back of the handset
kept 0 cm from the body. To maintain compliance with FCC and ISED RF exposure requirements,
use accessories that maintain a 0 cm separation distance between the user's body and the back of
the
handset. The use of belt clips, holsters and similar accessories should not contain metallic
components in its assembly. The use of accessories that do not satisfy these requirements
may not comply with FCC and ISED RF exposure requirements, and should be avoided.