26
Initial Configuration
T
To fill in the Management Server information
Note –
Once initial contact has been made, the engine receives a
certificate from the Management Center for identification. If the
certificate is deleted or expires, you must repeat the initial contact
using a new one-time password.
The engine now tries to make initial Management Server contact.
• If you see a “connection refused” error message, ensure that the
one-time password is correct and the Management Server IP address
is reachable from the node. Save a new initial configuration if unsure
about the password.
• If the engine is unable to contact the Management Server, make sure
there are no networking problems, that all information defined in the
Firewall element corresponds to what you entered in the configuration
wizard and, if NAT is in use, that you have configured contact
addresses for NAT as explained in the
Firewall/VPN Installation Guide
.
1. Highlight
Contact Management Server
and
press spacebar to activate.
2. Fill in the
Management Server
IP address and the
one-time password
that was created for
this engine when you
saved the initial
configuration.
3. (
Optional
) Fill in the Key fingerprint (also shown when
you saved the initial configuration). Filling it in
increases the security of the communications.
4. Highlight
Finish
and press E
NTER
.