V8.0.3x
©StoneFly, Inc. 2020 | All rights reserved
Page 32
StoneFly DR365V-1204 Getting Started Guide
Initial Installation
Adjusted settings are shown below. Enter
q
at the command prompt to exit back to the service
menu. Enter
q
again to exit out of the user console service.
Note
: the browser access to the SCVM Management GUI is blocked while the
SC Service
menu
is active. Also note that there can be a short delay before the SCVM GUI becomes available.
2.6.
Hyper-V Management Network Configuration
This section describes configuration of the Hyper-V Management Network.
IP Addresses
and
Hostnames
used in this section are for example only. Refer to Section 2.4 for VMware
Management Network Configuration.
Connect to System console. Attach a keyboard and monitor or use system IPMI KVM.
