10
866-795-1586 • WWW.SEWERNOZZLES.COM
TOOL SERVICE INFORMATION
TOOL SERVICE
The Warthog® WT also has a high pressure seal that will last between 150 and 300 hours. The seal
may leak at low pressure, but will seal at high pressures unless it has worn out. Refer to this manual for
assembly instructions.
Product training and proper tools are required to service this tool. If you are uncomfortable performing
the service, bring the WT to your authorized dealer.
The use of a bench vice and an arbor press is highly helpful. Take care throughout the entire procedure
to keep the internals clean and free from grit, lint, and contamination. Failure to do so could result in
premature failure after service.
TO FILL WITH VISCOUS FLUID
1. Fill the syringe with viscous fluid. This is
best done by unscrewing the handle from
the tube and pulling out the plunger. Pour
fluid into the tube; reassemble the syringe.
2. Hold the Warthog with the hose end
up as shown. Remove the Port Screw
(BJ 026) from the Warthog. Thread the
syringe fitting into the port, and slowly
squeeze fluid into swivel until excess fluid
comes out around the inlet end. If the
fluid coming out appears dirty or watery,
keep squeezing in new fluid until it comes
out clean.
3. Remove syringe from WT head, install
Port Plug.
VISCOUS FLUID FILL INSTRUCTIONS
BJ 026
Port Plug
WT 039
Set Screw
(DO NOT REMOVE)
BC 410
Syringe
REMOVE
TO FILL
LIST OF TOOLS:
• Bench Vice (recommended)
• Arbor Press (recommended)
• Medium size flat-head screw driver
• Pick
• Small needle nose pliers
• WT 612 Tool Kit
BA 100 Retaining Ring Pliers
WT 105 Seal Press Tool
LIST OF MATERIALS:
• Clean lint free rags or blue shop towels
• Lithium Soap Grease – StoneAge PN (GP 048
Grease)
• Isopropyl Alcohol or Denatured Alcohol
DISASSEMBLY