StoneAge Sentinel LWPS-100-X, Руководство пользователя

Страница: 12 / 32

12
866-795-1586 • WWW.STONEAGETOOLS.COM
5. Angle the
Idler Carriage
as shown to allow the
Idler Carriage to engage with the lower rail properly.
Rotate it back to the vertical position and slide it
towards the lower Rail Clamp.
(Figure 6)
6. Loosen the Rail Clamp Handle on the Horizontal
Drive . Align the Idler Carriage on the lower rail so
the Vertical Rail can slide into it. Slide the Vertical
Rail with (slots facing out) down through the
Horizontal Drive clamp and between the rollers
on the idler carriage. Adjust the position of the
vertical rail as required and secure the rail in place
by tightening the Rail Clamp Handle on the
Horizontal Drive. (Figure 7)
7. Remove the Quick Release Pin from the locked
position, pull back on the air motor to lift the
gear, and insert the
Quick Release Pin into the
unlocked position. This will allow the
Vertical
Drive Carriage to slide onto the rail without
pneumatic power. Center the carriage on the
vertical rail, pull out the
Quick Release Pin, let
the gear drop into place and verify the gear is
engaging the slotted rail correctly. Replace the
Quick Release Pin
into the locked position.
(Figures 8 & 9)
8. Loosen the handles on the four Rail Stops and
slide one onto both ends of the top horizontal rail
and both ends of the vertical rail. Rotate all the
handles so they face away from Horizontal and
Vertical Drives (as shown) and ensure that they are
securely fastened. (Figure 10)
LIGHTWEIGHT POSITIONER SET-UP
FIGURE 9
FIGURE 6
FIGURE 7
Rail
Clamp
Handle
Rail
Scraper
FIGURE 10
UNLOCK
Quick Release
Pin
Air Motor
Gear
LOCK
FIGURE 8
CAUTION
Verify the Positioner Clamps and Rail Clamps are
securely fastened and both drive carriages are
securely engaged and the pinned in the locked
position.
Never unlock the vertical drive once the guide
assembly and tractor are installed, as it may result
in the carriage sliping down the vertical rail and
may cause damage and/or injury.
WARNING
Failure to secure the Rail Clamps could result in
the carriages driving off the rails. This will create a
hazardous situation which, if not avoided, could
result in death or serious injury
TECH TIP:
The rail scraper is spring loaded to fit closely against
the rail to remove debris ahead of the idler roller.
Pulling up on the rail scraper or tilting the idler carriage
during installation will increase clearance and simplify
installation.