StoneAge AUTOBOX ABX-2L, Руководство пользователя

Страница: 14 / 36

14
866-795-1586 • WWW.STONEAGETOOLS.COM
1
2
GUIDE ASSEMBLY TO LIGHTWEIGHT POSITIONER SET UP
ATTACH GUIDE ASSEMBLY TO LIGHTWEIGHT POSITIONER
1. Using a 9/16 in. wrench, loosen all four rail clamp bolts located on the vertical carriage. Install the Guide Assembly into the rail
clamps and adjust position until the Guide Tubes are approximately 1/2 in. (13 mm) away from the tube sheet face. Tighten the
four rail clamp bolts.
2. Turn the pitch adjustment knob until the guide tubes are at the same pitch as the tubes in the bundle. Adjust the Tube Clamp
Bolt until the Guide Tubes are resting in the bottom of the “V” blocks. Make any fine adjustment to the Guide Tube pitch if
required and tighten the Tube Clamp Bolt.
NOTE: Over-tightening the Tube Clamp may damage thin wall guide tubes.
ABX 114 ADAPTER FOR BN9.5
( Ø.625 in. / 6 mm O.D.)
Guide Tubes
ABX 124 ADAPTER FOR BN18
( Ø.875 in. / 22 mm O.D.)
Guide Tubes
NOTE:
Adjust position until
the Guide Tubes are
approximately 1/2 in
.
(13 mm) away from the
tube sheet face.