Stone Age Manufacturing, Inc., © 2010-2014, All Rights Reserved.
11107 E 126th St. N., Collinsville, OK 74021 877-371-8861 www.stoneagemanufacturing.com
Cabinet Component System
SA-RDS-END
Please Read This Entire Document and Familiarize Yourself with All Steps and Kit Parts
Before Beginning Construction of the Concrete Pad or the Cabinet Component System Kit.
Materials required:
Landscape block adhesive or mortar.
Tools required:
Mallet or dead blow hammer, mason’s or rock hammer, caulk gun, saw with masonry blade.
Finishing will require additional tools and materials based on the type of finish being applied.
Notes: Panels may be trimmed with a masonry saw to fit out-of-square installations, or installations requiring smaller
dimensions than those of the kit. Flexibility is a key design feature, and you are not limited to the configuration shown in
this instruction - layouts may be modified or altered to different shapes as desired, however, it is not recommended that
the depth be altered, as this would require alterations of the welded upper brackets.
Pre-installation Preparation: Islands should be installed on a 4” steel-reinforced concrete pad or patio. Pier pad below
frost line if required in your region. Construct the pad with an appropriate outside border, to serve as a support ledge for
finish material, if required by the type of finish to be used.
Before beginning construction, draw the footprint of the kit on the pad or patio (chalk line recommended), to visualize the
layout.
Refer to Figure 1 for the layout of the kit, and Figure 2 for the types of brackets used in this island kit. Unfinished
Dimensions of this model is 33” wide by 16 1/2” deep by 36” tall (with top), or 34” tall (without top).
Installation Instructions
Figure 1
Figure 2
Patented
SA-BRSTS-2
Lower Bracket
SA-BRSTDW-2
Upper Bracket
Brackets
Radiused Islands
CCRE4
CCRE5
BRSTDW-2
(Top of Panel
Joints)
BRSTS-2
(Bottom of Panel
Joints)
BRSTS-2
(Top & Bottom
of End Panel
Joints)
Layout & Part Numbers
