Page 4
3. Unpacking and Assembling
Let the box stand on the pallet. Cut the front side open and let the machine roll
over the side of the box which has been folded down (see Figure) so that the run-
ning wheels are still standing on the pallet.
In this position, clip the side brushes which are on the dirt container under the side
brush plate (in the front exterior portion of the machine) (see Figure). Apply light
pressure to twist the brushes upwards until you can feel them lock into place. Note:
do not tip over the machine in this process: there is the danger of battery acid
running out.
First roll the machine from the box and from the pallet.
Afterwards, put the steering handle in the upright position, pull it downwards into
the two tappets completely (see Figure) and tighten it with the two thumb screws.
Afterwards, open the tank nozzle located in the front part of the machine.
Top up approx. 1 litre unleaded regular fuel.
Please note that the engine was already filled with approx. 100 ccm universal lu-
bricant – 15W40 at the factory.
4. Starting Up/Operating
After the machine has been assembled, it is immediately ready for operation.
First of all, the two lateral brushes should be lowered. For this purpose, push the
thumb washer forward (see Figure) with your foot until the brushes just touch the
floor.
It is possible to adjust the height of the main sweeping brush using the adjustment
handle on the left side of the machine (under the dirt collector) (see Figure). Please
ensure that the brush tips only touch the floor lightly. If the brushes are adjust too
low, this increases the wear on the brushes and the gear components as well as the
power consumption. Position 1 - the highest brush position (for new, unworn roll-
ers), position 5 - the lowest brush position (for worn brushes or very uneven floors
for a short period of time).
