1
3
2
4
IR Emitter
PoC
TPHD402PR 1
HDTV
HDTV
TPHD402PR 2
HDTV
HDTV
TPHD402PR 3
HDTV
TPHD402PR 4
HDTV
PoC
PoC
PoC
IR Matrix
The IR signal is sent by corresponding IR remote, then it is transferred to HDBaseT
receiver, then to corresponding zone of the matrix through the twisted pair, finally it is
transferred to IR OUT port and received by controlled device.
Switching Operation
: (4 IR IN ports correspond with 4 HDMI input ports separately in
default mode.)
a) Sending command (reference to
4.3 RS232 Control)
: [x1]R[x2].
x1: Corresponding to the 4 IR OUT ports of the matrix, the IR transmitter connected
to this port can be placed at IR receiving area of output device or SUHM44HB
itself.
x2: Corresponding to the zone (receive IR signal from HDBaseT receiver with IR IN
port connects with IR receiver) number of SUHM44HB.
Example: Send command
“3R2.” to transfer IR signal received from zone 2 to IR
OUT port 3.
4.3 RS232 Control
4.3.1 Connection with RS232 Communication Port
Except the front control panel, the SUHM44HB can be controlled by far-end control
system through the RS232 communication port. This RS232 communication port is a
female 9-pin D connector. The definition of its pins is listed in the table below.
