Stollmann
E + V GmbH
C11/G2
User Guide
Author: ta
Date saved: 06.04.09
Ref: C11G2_User_Guide_r02.doc
Revision: r02
Page 8 of 22
3.3 Getting Started
3.3.1 Establishing a Bluetooth Connection Between two C11/G2
Using the Serial Port Profile (SPP)
First of all, determine the Bluetooth addresses of the two C11/G2. To do
so, connect each of the C11/G2 to the COM port of the PC and readout
the Bluetooth address using the “AT**BOAD” command as described in Chapter
3.2
Configuration
.
You can either use a single PC with 2 COM ports or two separate PCs with one
COM ports each.
Now you can establish a connection from one C11/G2 to another by
issuing the “ATD<Bluetooth Address>” command.
Figure: Establishing a Bluetooth connection between two C11/G2
If the connection was established successfully, the originating C11/G2 will
issue the message CONNECT. You can now send data transparently between the
two C11/G2.
To terminate the Bluetooth connection, click “Disconnect” in the terminal emulation
program. If the Bluetooth connection is disconnected successfully the remote
C11/G2 will issue the message NO CARRIER.
