Fig. 6
Attach Vent Assembly to Grate
Heater Unit with remaining 2 Phil-
lips screws.
Attach here
Vent Assembly
Grate
Heater
Unit
Fig. 8
Use feet adjustment bolts to level
unit in fireplace. Bolts can be ad-
justed up and down with a 5/8” end
wrench.
Leg
5/8” End Wrench
Adjustment
Bolt
Fig. 7
Trim Cover to fit opening. Place end
caps over trimmed ends, making
sure to place the cord cut-out over
the cord.
Trimmed Cover
Cap w/ Cord Cut-out
Cord
Powe
r Cord
Fan
Thermal Switch
Variable Speed
Switch
Power Cord
Switch/Fan
Green
Fan Green
>
Black
Switch Black
>
White
Fan Black
>
Green
Black
White
Black
Green
Black
Fig. 5
Grate Heater
Installation Instructions - Photo Addendum (continued)
NOTE:
Unit will not run until the thermal switch reaches 120° F. If you wish to test the
unit before finishing installation, heat the thermal switch (
silver disk on back of Blower
Assembly
) with a lighter or torch after setting the variable speed switch on.
Fig. 6
Attach Vent Assembly to Grate
Heater Unit with remaining 2 Phil-
lips screws.
Attach here
Vent Assembly
Grate
Heater
Unit
Fig. 8
Use feet adjustment bolts to level
unit in fireplace. Bolts can be ad-
justed up and down with a 5/8” end
wrench.
Leg
5/8” End Wrench
Adjustment
Bolt
Fig. 7
Trim Cover to fit opening. Place end
caps over trimmed ends, making
sure to place the cord cut-out over
the cord.
Trimmed Cover
Cap w/ Cord Cut-out
Cord
Powe
r Cord
Fan
Thermal Switch
Variable Speed
Switch
Power Cord
Switch/Fan
Green
Fan Green
>
Black
Switch Black
>
White
Fan Black
>
Green
Black
White
Black
Green
Black
Fig. 5
Grate Heater
Installation Instructions - Photo Addendum (continued)
NOTE:
Unit will not run until the thermal switch reaches 120° F. If you wish to test the
unit before finishing installation, heat the thermal switch (
silver disk on back of Blower
Assembly
) with a match, lighter or torch after setting the variable speed switch on.
