STOKVIS ENERGY SYSTEMS SMART DISPLAY UNIT, Руководство пользователя, Страница: 3 / 8

2. Display Access.
2.1 Description
Pressing the & the b uttons
will navigate through the various
screen page s as this flow cha rt
example shows.
2.2 Parameters.
The follo wing screen pages
have pa rameters th at can be
changed via the display but-
tons:
Find the scre en page sho wing
the parameter that you wi sh to
change by pressin g the or
th buttons.
Pressing the button will
move the cu rser to the line of
the display you require.
Once the parameter h as been
modified, pressing the but-
ton will move the curser up to
the top line of the display.
The pa rameter ha s no w been
successfully changed.
2.3 PIN protection.
The SDU is sup plied with PIN
protection. If you attem pt to
change a parameter the display
will ask for a PIN number.
Enter the first numbe r of your
PIN using the and but-
tons then press to move the
curser to the next nu mber.
Once the last number has been
entered an d butto n is
pressed, the display will return
to the param eter that you were
attempting to adjust.
If the corre ct code ha s been
entered the parameter wi ll be
adjustable.
If the incorre ct code h as been
entered the display will ask you
to enter the PIN again.
The PIN entry display will time-
out 10 seconds after th e last
button press. The PIN itself will
remain active for 2 minutes after
the last button is pre ssed after
which it will expire.
2.3.1 PIN entry.
etc.
YOUR PIN NUMBER IS SHOWN
ON THE LAST PAGE OF THIS
MANUAL
Sensor 1
Room Sensor
18.60
DegC
Sensor 2
Duct Sensor
38.96
DegC
Sensor 3
Outside Air Sensor
7.4 DegC
Knob 1
Occupied Setpoint
20.00
DegC
Knob 2
Non Occupied Setpoint
8.00 DegC
Knob
Switch
Time Zone
Knob 1
Occupied Setpoint
20.00
DegC
-
PIN? 5 ***
-
PIN? 6 ***
-
PIN? * 5 **
-
PIN? * 4**
-
PIN? ** 5 *