Electrical Supply
Installation must be carried out by a qualified electrician in
accordance with BS 7671:2008 Wiring Regulations.
230/240V AC 50/60Hz mains supply.
Site conditions: LED equipment is more susceptible to
static damage and overvoltage than previous technology.
Before handling or connecting to the mains supply ensure
that all MSL products are protected from static discharge
and that the mains supply is to regulation. (230V +10
-6%)
This fitting is supplied with a Xicato LED module. Refer to
the fitting label for the module version and wattage. More
information on the module can be found at
www.xicato.com/support
Mains cables must be double insulated, strain relieved
and separated from E.L.V output cables.
All connections must be made before switching on mains.
The light source contained in this luminaire shall only be
replaced by the manufacturer or his service agent or a
similar qualified person.
All lighting equipment is delicate and easily damaged
through misuse or inappropriate installation (mechanical
or electrical). Repairs and replacements may cause
delays and will be chargeable. Contact MSL for support if
required. For full warranty terms & conditions please visit
our website.
Dimming control circuit source must be of SELV insulation
class.
This fitting can be suitable for DALI, 1-10V, on board or
Bluetooth dimming. Please check the product label for
the dimming protocol of the supplied fitting.
Installation
Check that the mounting surface is suitable for the
installation of this fitting.
A suitable hole is required for incoming mains supply.
Step 1 Secure the mounting bracket to the mounting
surface with suitable fixings.
Step 2 Make Live and Neutral connections to the
SELV LED PSU and the Earth connection to
the supplied connectors. Punch holes through
the rubber inserts as required.
Additional dimming connections (if specified)
will be marked for easy identification.
Dim (+)
purple
Dim (-)
grey
Step 3 Attach the body of the fitting to the mount
bracket and secure with the supplied M4
fixings. Ensure these fixings are fully
tightened. Take care not to trap any cables
when securing in place.
WARNING: Do not look at exposed LED lamps in
operation. Eye injury can result.
Cleaning:
Fully isolate the fitting and allow to cool.
Clean the fitting with a damp lint free cloth from a mild
solution of soap and water. The fitting must be
completely dry before reconnecting power.
Incompatible or abrasive chemicals can damage the
fitting, contact MSL for advice if required.
Bluetooth Low Energy (If applicable)
BLE networks should be secured during
commissioning via the Xicato Control Panel software.
This fitting can be dimmed via Bluetooth using the
Ximtroller app available from the Apple App Store.
STX2.70 Integral.pdf 2 16/04/2020 09:22:13
