Insert tool.
Holes for tool should be in
line with mounting holes.
Tilt and Pan Adjustment
Step 1 Remove the magnetic coverplate with the gloves
supplied. Push the coverplate down and rotate
anti-clockwise to disengage the magnets and
remove.
Step 2 Insert supplied tool into the front bezel tool
holes. Twist to loosen bezel.
Step 3 Loosen the three screws securing the lamp tube
and adjust the tilt and pan as needed.
Once the fitting has been adjusted, reverse the procedure
to reassemble.
1
2
Loosen Screws
ENSURE that the locks are NOT OVER
TIGHTENED
Use the Allen key as shown to be
Finger Tight only
Install in well drained ground
Surface Gradient must run away
from the fitting
Opening tool
Badger M with Install Sleeve.pdf 5 20/08/2020 15:49:24
