Stiroplus SP1045, Инструкция по эксплуатации

Страница: 19 / 21

18
ADDITIONAL TABLE
Problem Causes Solutions
The appliance has
switched off The appliance will turn off automatically
after 10 minutes if no steam spray out from Press down the power switch, the power
indicator turns on.
Dirty water and mineral deposits come
out of the
soleplate or the
soleplate is dirty. Calcium particles and minerals present
in the water have deposited in
the steam holes and/or inside the
appliance. Use a damp cloth to clean the soleplate.
Descale the appliance by following the
operation in paragraph “CLEANING AND
MAINTENANCE”.
There is not enough water in
the water tank. Fill the water tank with water.
The appliance is not hot
enough to produce steam. Wait until the temperature indicator
extinguish on iron and the indicator of the
defaulted steam rate changes from flashing
to illuminating on base.
The water tank is not placed correctly. Reposition the water tank properly.
The appliance is not switched
on. Connect the plug to wall outlet and press
down the power switch.
The appliance
produces a
pumping sound Τhe sound tells you that water is pumped
into the boiler.
If the pumping sound does not stop,
switch off the appliance and remove the
plug from the wall socket. Contact the
authorized service center.
Water drops come out of the soleplate There may be dripping water during
spraying steam when the temperature is set
at the second setti ng (●●) or lower than the
second setti ng (●●) .
For steam ironing, turn temperature dial
within the steam section, as shown in the
TEMPERATURE DIAL paragraph.
TROUBLESHOOTING
The appliance
does not produce
steam.
Setting Temperature Fabric
The first setting 70<T<120 Acetate, elastane, polyamide, polypropylene
The second setting 100<T<160 Cupro, polyester, silk
The third setting 140<T<210 Triacetate, viscose, wool
Maximum 170<T<225 Cotton, flax