13
AFTER SALES SUPPORT
1300 886 649
AUS
MODEL: STR-SSDW14 PRODUCT CODE: 10933 09/2019
Installation (Cont.)
Cold water connection
• Connect the cold water supply hose to a threaded 3/4”
connector. During use, the dishwasher will heat up the
water to the required temperature. Make sure the hose is
not kinked or squashed and is fastened tightly in place
(Fig. 4).
• If the water pipes are new or have not been used for
an extended period of time, let the water run to make sure it is clear and free of
impurities. This step is necessary to avoid the risk of the water inlet being blocked
and damaging the appliance.
•
WARNING!
Always close the water tap after using the dishwasher.
Drain hose connection
• The drain hose must be connected to the drain hose connector at the back of the
dishwasher. Insert the drain hose into a drain pipe with a minimum diameter of
40mm, or let it run into the sink, making sure to avoid bending, crimping or squashing
it. The height of drain pipe must be less than 1000mm from the floor. The free end of
the hose must not be immersed in water to avoid the backflow of water.
• Follow the illustration below (Fig. 5) when installing the drain hose connection
according to option A or B.
• The drain hose must be correctly fitted in order to prevent water leaks. It should be
connected at a height of no more than 1m (maximum) and secured with a hose clip.
• If you need to drain any excess water from hoses and the sink is higher than 1m
from the floor, you will need to drain the excess water into a bowl or container held
underneath the pipe and lower than the sink.
• If you need a drain hose extension, make sure to use a similar hose that is no longer
than 4 metres, otherwise the cleaning effect of the dishwasher could be reduced.
Fig. 4
Fig. 5
Benchtop
Drain hose
Water inlet
Drain pipe
Mains cable
Back of dishwasher
max. 1000mm
∅
40mm
