12
AFTER SALES SUPPORT
1300 886 649
AUS
MODEL: STR-DW12-W PRODUCT CODE: 61605 07/2018
Getting Started (Cont.)
Cold water connection
• Connect the cold water supply hose to a threaded 3/4”
connector (Fig. 2). During use, the dishwasher will heat up
the water to the required temperature. Make sure the hose
is not kinked or squashed and is fastened tightly in place.
• If you need a drain hose extension, make sure to use a
similar hose that is no longer than 4 metres, otherwise the
cleaning effect of the dishwasher could be reduced.
• If the water pipes are new or have not been used for an extended period of time, let
the water run to make sure it is clear and free of impurities. This step is necessary
to avoid the risk of the water inlet being blocked and damaging the appliance.
•
WARNING!
Always close the water tap after using the dishwasher.
Drain hose connection
• Connect the water drain hose to the drain hose connector at the back of the dish-
washer. Then connect the other end of the drain hose to a drain pipe with a minimum
diameter of 40mm, or let it run into a sink, making sure to avoid bending, crimping or
squashing it. The top of the hose must be less than 1000mm from the floor.
• Follow the illustration below (Fig. 3) when installing the drain hose connection
according to option (A) or (B).
• The drain hose must be correctly fitted in order to prevent water leaks. It should be
connected at a height of no more than 1m (maximum) and secured with a hose clip.
Fig. 2
Fig. 3
Drain hose
NOTE:
The top of the hose
must be no higher than
1000mm.
Benchtop
• If you need to drain any excess water from hoses and the sink is higher than 1m
from the floor, you will need to drain the excess water into a bowl or container held
underneath the pipe and lower than the sink.
