For more information
please visit
www.stirlingappliances.com.au
or call
1300 886 649
Quick Start Guide
This Quick Start Guide only contains basic information. Please read the full manual for
comprehensive instructions and safety advice before first use. The relevant sections in
the manual are listed in brackets below.
IMPORTANT:
Do not use detergent solution on carpet. Test the
solution in an inconspicuous area before using it on a suitable
hard floor.
CAUTION:
To avoid scalding and burns, take extra care when
using the steam mop. Never point the mop at persons, pets or
plants, and only use it on surfaces that can withstand high heat.
Model Number
SC270S
Colour
White and Blue
Power
1400W-1600W
Warranty
3 Years
Version
QSG-V1.2
Carpet and hard floor steam cleaning
Step 1
Attach the steam mop head and handle to the steam
mop body as per instruction manual (page 9).
Step 2
Remove the water tank from the back of the unit, fill it
with 500mL of tap water and reattach (page 10).
Step 3
Fasten a cleaning pad to the base of the steam mop and
ensure the solution tank dial is set to CLOSE (page 12).
Step 4
The steam mop is now ready for use on sealed hard floors.
To use it on carpet, place the mop head into the carpet
glider for better manoeuvrability (page 13).
Step 5
Press the ON/OFF switch to turn on the steam mop. Place
your foot over the shoe symbol on the mop head and
gently pull the handle downwards to recline it, then pull
the trigger on the handle to release the steam while
moving the mop backwards and forwards (page 12).
Step 6
If you want to clean hard floors with the detergent
solution, switch off the unit. Remove the solution tank
from the front of the unit, fill it with a maximum 180mL
POWERFORCE Steam Mop Solution and reattach (page
11). Then turn the solution tank dial to OPEN for maximum
solution delivery. (You may turn it clockwise towards the
CLOSE position to decrease the amount of solution.)
Switch on the unit and when the ready indicator
illuminates, proceed as above.
