13
AFTER SALES SUPPORT
1300 886 649
AUS
MODEL: MDR70-VR031 PRODUCT CODE: 61494 06/2018
Installation (Cont.)
• Using a drill with a
∅
14mm drill bit, drill four holes for the expansion bolts
according to the drawing on the positioning paper (Fig. 4). The hole depth must be
60mm.
NOTE: If you are installing the appliance on a tiled wall, use a special
∅
14mm drill
bit for use on tiles (Fig. 5).
Fig. 4
Fig. 3-A
Fig. 3-B
Fig. 5
Step 3: Wall preparation
• Determine the dryer position on the wall and, using a spirit level, draw a level line
the length of the positioning paper (Fig. 3-A).
NOTE: Ensure the screw holes are in an appropriate position: they must not overlap
with any power outlets, cabling or taps.
The bottom edge of the positioning paper must be at least 45cm+ above floor level.
• Remove the adhesive paper from the back of the position paper and paste the
paper horizontally to the wall (Fig. 3-B).
